Jbl CS 360 Xcite Manuel d'utilisateur télécharger pdf (Page 6)

The CS360 satellites and center channel are designed

to be mounted on the wall. There is a fixed-mount wall

bracket and an adjustable wall bracket provided for each

satellite and the center channel. Each speaker bracket will

require up to four 38 mm (1-1/2") #10 wood screws; each

screw should be fastened to a wall stud. If a wall stud is

unavailable, install an anchor appropriate for a 38 mm

(1-1/2") #10 screw.

NOTE: The customer is responsible for the correct selec-

tion and use of mounting hardware (available through

hardware stores) that will ensure the proper and safe

wall-mounting of the speakers.

Fixed-Mount Wall Bracket

Step 1. Mark the positions on the wall where you would

like to place the mounting screws.

Step 2. Attach the bracket to the wall using two screws

(not included).

Step 3. Remove the rubber ring on the bottom of the

satellite and hold the satellite or center channel speak-

er in the right position on the bracket.

Step 4. Attach the short Phillips screw into insert on

bottom of speaker and tighten.

Step 5. Attach speaker wire as shown on page 7.

NOTE: The fixed-mount wall bracket for the center

speaker is the one with the wide support plate. The

center speaker has to be mounted horizontally when

using the fixed-mount bracket. See image on page 4.

In order to attach this bracket, first detach the stand

and remote sensor that are fixed to the center speaker

from the factory. Simply loosen and remove the large

Phillips screw at the bottom of the stand. The remote

sensor and the stand come off as two separate items,

and you may now position the remote sensor freely, if

you decide to use it. The bracket should be attached to

the wall first, then the cables should be connected to

the speaker, and finally you can attach the speaker to

the bracket with the large Phillips screw from beneath.

Adjustable Wall Bracket

Step 1. Remove cap over threaded insert on rear of

speaker.

Step 2. Mark the positions on the wall where you would

like to place the mounting screws.

Step 3. Place bracket against the wall and fasten four

38 mm (1-1/2") #10 wood screws through the bracket’s

screw holes into the wall. If a wall stud is not available,

use an appropriate anchor.

Step 4. Unscrew round collar (C) from bracket (A).

Step 5. Screw the ball and shaft assembly (B) to the

short Phillips screw insert on the back of the satellite

or the center channel (do not use the bottom insert on

either speaker). Back out 1/2 of a turn and tighten the

nut against the speaker. If the ball and shaft assembly

is not backed out before tightening the nut, perform-

ing Step 8 below may dislodge the threaded insert

in the speaker housing and permanently damage the

speaker.

Step 6. Attach speaker wire as shown on page 7.

Step 7. Drop round collar (C) over ball and shaft assem-

bly (B) that is mounted to the speaker with the finished

side of the collar facing the rear of the speaker.

Step 8. Carefully push the ball straight into the socket

mounted on the wall, angle the speaker as desired and

tighten the collar using the enclosed metal bar.

Metal bar

Figure 3. Bracket on wall

Before mounting the center speaker on an adjustable wall

bracket, remove the base and remote sensor assembly as

described under “Fixed-Mount Wall Bracket” above.

Wall-Mounting the Satellites and Center Channel

1 2 3 4 5 6 7 8 9 10 11 ... 15 16

Commentaires sur ces manuels

Pas de commentaire

Jbl CS 360 Xcite Manuel d'utilisateur Page 6

Commentaires sur ces manuels

Produits connexes et manuels pour Systèmes de cinéma à domicile Jbl CS 360 Xcite