Jbl HTI6C Manuel d'utilisateur télécharger pdf (Page 7)

7

NEW CONSTRUCTION

PAINTING THE SPEAKER

FRAME AND GRILLE

HTI Series loudspeakers can be

painted to match any decor.

If you wish to change their color,

the satin finish on the grille and

frame will function as a primer

coat. Before painting, install the

paint shield (in the assembly kit)

securely into the recess in the

baffle. This will protect the

speaker components and baffle

from paint residue.

Use a high-quality spray paint,

and apply a thin coat of color.

Be certain the grille perforations

remain free of paint. Filling them

with paint will diminish the

sound quality.

Note:

Gently remove the acousti-

cal foam blanket from the grille

before painting. Reattach the

blanket after the paint has dried.

You will need to purchase the correct rough-in frame kit for your model:

Speaker Model Rough-in Frame Kit

HTI6 RIF6

HTI8 RIF8

HTI6C RIF6C

Detailed installation instructions are supplied with the rough-in kit.

TROUBLESHOOTING

If there is no sound from any

of the speakers:

• Check that receiver/amplifier

is on and a source is playing.

• Check all wires and connections

between receiver/amplifier and

speakers. Make sure all wires

are connected. Make sure none

of the speaker wires are frayed,

cut or punctured.

• Review proper operation of

your receiver/amplifier.

If there is no sound coming

from one speaker:

• Check the “Balance” control

on your receiver/amplifier.

• Check all wires and connec-

tions between receiver/amplifier

and speakers. Make sure all

wires are connected. Make sure

none of the speaker wires are

frayed, cut or punctured.

If there is low (or no) bass output:

• Make sure the connections

to the left and right “Speaker

Inputs” have the correct polarity

(+ and –).

• Consider adding a powered

subwoofer to your system.

• In Dolby* Digital or DTS

®

modes,

make sure your receiver/proces-

sor is correctly configured. When

using a subwoofer, make sure the

subwoofer output of the

receiver/processor has been

enabled. If no subwoofer is

being used, make sure the

left and right front and rear

speakers have been config-

ured as “LARGE.” See your

receiver/processor’s owner’s

manual for futher information on

correct speaker configuration in

Dolby Digital, DTS and other

surround-sound modes.

If the system plays at low

volumes but shuts off as

volume is increased:

• Check all wires and connec-

tions between receiver/amplifier

and speakers. Make sure all

wires are connected. Make sure

none of the speaker wires are

frayed, cut or punctured.

• If more than one pair of main

speakers is being used, check the

minimum-impedance require-

ments of your receiver/amplifier.

1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire